Originally Posted by
Jack Flesher
The scanning area cutout on the 4x5 holder is 93mm x 113mm -- on my negs, the 93mm dimension is just inside the borders, so no big deal there for anybody. The 113 slot requires me to choose where to trim about 6mm off either/both sides. Not a big issue for me since I tend to shoot a little loose anyway, but could be a serious issue if you compose to the edge...
I will say it does look like one could easily remove 3mm frrm each side of that holder and still have ample support, but I have no idea how that would affect the scan. Also, the MF holders are templates that mount inside the 4x5 slot...
Bookmarks