I was shooting some architecture today with my Toyo 810M camera and when I got out my level I determined that the full open position for the back of the camera is less than vertical. Yes, I can push the black release bars and get past the full open stops to get it to 90 degrees to the camera bed, but the camera should open up to precisely the 90 degree position just like the front standard.
There are a set of allen bolts in the real axis assembly. Does anyone know if that is that where the adjustment is to get things squared up?
I guess I can call customer service in the AM but it is like a burr under my saddle and I thought I would check out the experience here.
Thanks. If I do not get an answer, I will post the response from Toyo service tomorrow.
Cheers!
Bookmarks