More progress on my first and only darrkroom....http://photo.net/photodb/folder?folder_id=957873
Enlargers will include an 8x10 CLS-2000, a Zone VI 5x7, and a Saunders LPL 4x5.
The newest addition is the 6 1/2 foot stainless table wet area and my Print developer tank with 5 slots for chemicals. One can't see in the newest pictures, but at the end is a 5 foot plus counter top with a sink I plan to use my jobo unit in that area to develop primarily film and will have a Zone VI 11x14 washer and when I print a 20x24 print, I have a similar washer of several sheets at a time.
I had hoped to a least try my first prints this weekend, but duties called and it should be next weekend. By that time, I should have a couple of safelights installed and an exhaust fan.
Essentially, only 1 large print can be developed at a time in this system. Once the print has been developed and fixed....then it will be moved to the area where my JOBO system is presently located and an Archival Wash Tank, e.g., Zone VI, will be used.
The time saving feature I see will be the fact I don't have to mix the paper chemicals each time. Thus I can expose the paper and proceed to the wet area.
Again, this is my first darkroom and thus I am a newbie who needs lots of guidance.
I thank everyone for your assistance and guidance. If you are in the neighborhood, get a hold of me and we can print some negs.
Jon - Looks real good. The only thing that I'd change would be to install 2 filters on the water panel, one on each of the input lines instead of just the single filter on the output. Might as well protect the panel as well. Have fun,