Results 1 to 3 of 3

Thread: Time of HP-5 in Xtol with Jobo Processing

  1. #1

    Time of HP-5 in Xtol with Jobo Processing

    I have been doing zone system testing with HP-5 in Xtol 1:1 in a Jobo processor. My time for normal development with zone VIII at 1.30 density is 12 min. at 70 degrees. This time is 50% greater than the time published by Kodak, which makes me wonder if I have done something wrong. Has anyone else had a similar experien ce with HP-5, Xtol, and Jobo processing?

  2. #2

    Join Date
    Mar 1999
    Posts
    769

    Time of HP-5 in Xtol with Jobo Processing

    I'm not positive about this but aren't the Kodak figures for rotary processing shorter than their times for processing in tanks? In other words, Kodak suggests a shorter development time to compensate for the constant agitation of a rotary processing system. Jobo, on the other hand, recommends a 5 minute presoak and about the same time as normal i.e., the long presoak serves to compensate for the constant agitation of rotary processing. So if you did use the presoak as per Jobo's recommendations, your times are likely to be longer than the Kodak recommendation. In any case, its a moot point, as long as you get the densities you want on the negative. Hope this helps. DJ

  3. #3

    Join Date
    Nov 1998
    Posts
    339

    Time of HP-5 in Xtol with Jobo Processing

    If you don't use a presoak the time for continuous agitation will be shorter tha n for intermittent agitation; if you use a presoak it'll be the same or longer.

    The only thing that counts is your results.

    FWIW, my time for HP5+ in Xtol 1:1, intermittent agitation, is 10'30"/70F, EI 400, Zone I at .10 DU above fb&f, Zone VIII at 1.37 DU.

Similar Threads

  1. TMAX 100 in XTOL 1:1 Jobo Expert
    By Serge J-F. Levy in forum Darkroom: Film, Processing & Printing
    Replies: 14
    Last Post: 17-Nov-2005, 07:23
  2. Xtol 1:3 in a Jobo 3006
    By Ed Richards in forum Darkroom: Film, Processing & Printing
    Replies: 12
    Last Post: 10-Jun-2005, 09:22
  3. tri-x in xtol development time (can you dilute?)
    By dan otranto in forum Darkroom: Film, Processing & Printing
    Replies: 6
    Last Post: 5-Mar-2005, 13:36
  4. Developing time for 4x5 FP4 with XTOL in BTZS Tubes
    By Nguyen "Billy" Kok in forum Darkroom: Film, Processing & Printing
    Replies: 1
    Last Post: 22-Jan-2002, 15:35
  5. Processing Ilford Delta 100 in XTOL
    By John C. Morris in forum Darkroom: Film, Processing & Printing
    Replies: 1
    Last Post: 26-Jul-1998, 17:48

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •