Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Holder for scanning 5x7

  1. #11

    Join Date
    Feb 1999
    Posts
    563

    Re: Holder for scanning 5x7

    I, too, just lay the 5x7 neg directly on the glass and have not had any problems (knock on wood).

  2. #12

    Join Date
    Mar 2017
    Location
    Del City, OK
    Posts
    137

    Re: Holder for scanning 5x7

    Quote Originally Posted by Oren Grad View Post
    My sheet film negatives are flat after processing, but sometimes they curl slightly while sitting on the glass in my V700, presumably from the heat of the lamp or the scanner's electronics warming up. It's enough to cause trouble in the corners of the scan, so a top AN glass or at least some way of holding the corners down is helpful.
    I had an issue with that as well. I used tiny pieces of blue painters tape to hold down the corners on the glass. I positioned it so it was just barely kissing the edges of the negative. And I used the special blue painters tape with low residue and cleaned the glass after every scan. It would have worked, but itís always humid as hell here, so Newton rings were unavoidable, even with the emulsion side down. Hence why I settled on a wet scan. And honestly, itís a lot easier and cheaper than I originally thought it would be.

    Another idea would be to place the negative in a negative holder for an enlarger. I havenít tried it for scanning, and height may be an issue (as well as scratching the glass), but itís what I use for DSLR scanning negatives against a light box and it works really well. Again, I tried just about everything else before coming up with the simplest, cheapest, and most obvious solution.

  3. #13

    Join Date
    Jun 2008
    Location
    Melbourne, Australia
    Posts
    438

    Re: Holder for scanning 5x7

    In theory your using the 8x10 area so you just need to lay straight on glass and use the Epson plastic edge mask/guide. The cut out is needed to allow the machine to set colour balance.

Similar Threads

  1. Espon V850 and Better Scanning wet scan holder
    By Steven Ruttenberg in forum Digital Processing
    Replies: 27
    Last Post: 1-Apr-2018, 06:02
  2. Wet Mounting on Better Scanning holder - Worth it?
    By sully75 in forum Digital Hardware
    Replies: 9
    Last Post: 28-Dec-2011, 12:24
  3. 617 Negative Holder for Scanning
    By GX617 in forum Digital Hardware
    Replies: 1
    Last Post: 27-Oct-2006, 14:01

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •