I purchased an estate sale Photogenic 500ws power pack model AA01. It looks "rode hard and put up wet". but will fire a strobe on all outlets.
However, it is missing the "power ratio plug" The socket for this plug looks like an 11 pin vacuum tube socket and sets the flash ratio between the heads. (Photogenic listed 10 or 15 different ones for all possiable combinations.)
One of the problems with getting wonderful deals, is that it will just about double my investment to buy a even a single plug.
Does anyone know if the unit defaults to full power or min power without the plug or where I can find wireing diagrams on the net to make my own.?
I found some blank plug for 25 cents each at an electronics surplus store so if I had wireing diagrams, I would just need some resistors, jumpers and solder and I suspect I would be set.