Results 1 to 5 of 5

Thread: Epson V850 For Wet Plate Scans???

  1. #1

    Epson V850 For Wet Plate Scans???

    Hi. Do any of you scan 8x10 aluminum wet plates on the V850. Basically, using the scanner as a flat bed, what scanning specs do you use?
    Joseph Kayne
    Joseph Kayne Photography
    Fine Large Format Photography
    www.josephkaynephoto.com

  2. #2
    jp's Avatar
    Join Date
    May 2009
    Location
    Maine
    Posts
    4,702

    Re: Epson V850 For Wet Plate Scans???

    I have scanned plates with the v700 which should be similar. I put a coin under each corner of the metal plate and scan it as a reflective object. The slight spacing prevents moire or damage to the emulsion or finish. If your plates are consistently the same size, you could also make a holder out of thin matboard or plastic to position the plates.

  3. #3

    Join Date
    Jul 2016
    Posts
    2,019

    Re: Epson V850 For Wet Plate Scans???

    Well, it would be good something thinner than a coin, I guess reflective scanning uses the lower res lens, that may have focus in the bed surface, so it may be good to separate the plate, but IMHO the smaller is the separation the better.

  4. #4

    Join Date
    May 2016
    Location
    Licking County, Ohio
    Posts
    297

    Re: Epson V850 For Wet Plate Scans???

    I scan mine that way. Works fine. I just lay them on the glass and the focus is spot on (test to confirm that yours is the same). I scan them as a 48 bit reflective (which uses the less-good lens with the plane of focus at the surface of the bed glass) typically at 720dpi. That sounds silly low but when you get to thinking about how big of a print you can make from a 720dpi scan of an 8x10, it's more than enough.

  5. #5

    Join Date
    Jul 2004
    Posts
    191

    Re: Epson V850 For Wet Plate Scans???

    I use a v750 for scanning my plates prior to varnishing, set at 600 dpi (figure my plates don't have any greater resolution than a standard print). It takes some fairly subtle editing to reproduce the look of a sandarac varnished plate particularly in the lighter areas of the images. I've once or twice seen newton rings in my scans, but it's quite rare. Might be more of an issue if I did glass plates. I'm looking into using a good copy stand instead of the scanner, as I think it doesn't handle the reflectivity really well.

    Cheers!
    Bill

Similar Threads

  1. First scans with Epson V850
    By Steven Ruttenberg in forum Digital Processing
    Replies: 54
    Last Post: 26-Mar-2018, 09:09
  2. Epson V850: better optics, *really*?
    By sharding in forum Digital Hardware
    Replies: 27
    Last Post: 15-Aug-2017, 12:54
  3. Epson V850-Epson V800, what is the next step up.
    By Smorton in forum Digital Hardware
    Replies: 21
    Last Post: 1-Jul-2016, 10:31
  4. Replies: 3
    Last Post: 13-Dec-2015, 09:31
  5. Opinions/Experience thus far on the Epson V850?
    By Daniel Stone in forum Digital Hardware
    Replies: 1
    Last Post: 13-May-2015, 16:03

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •