Good Morning,

I need the expert assistance of all you Eversmart Pro users. I recently acquired an Eversmart Pro running the Scitex 2.5.1 software. After calibration, the first few test scans look great. Problem is, the maximum DPI setting in the software is 2540. I was under the impression the Pro series had a maximum DPI of 3150. I have fiddled with the settings (No software manual) thinking something within the software was limiting the dpi. No success. I am operating blind at this point and am hoping someone has a suggestion or two or at least software documentation that may be helpful.

I much appreciate your time.