Contact printing stand

[Ironage]

This is a simple idea which I haven't seen before. I needed an adjustable table to hold my contact printing frame and UV exposure meter while making ziatype prints in the sun. I took a simple hard wood plywood board and then glued another board at the bottom so my stuff wouldn't fall off. Final step is to drill a hole in the back and screw in a threaded tripod mount.

Then I mounted it on tripod and adjusted it into the sun. As an added bonus it makes a great music stand!


Sent from my iPod touch using Tapatalk

[David Schaller]

Nice idea! This never would have occurred to me. In fact I have a music stand, and now I will use it. Thanks!