Here are the specs.
Film: Bergger BPF 200.
Processed on rotory..Unicolor drum on Unicolor auto reversing base. All temps 68 degrees.
five min. water pre wet.
Dev: D-76 1:1, 13.5min.
water stop.
Fix.
Results:
Zone I came out at 200 ASA.
Then I processed a zone V and VIII negative together for the same time. (13.5 min.). Zone V was .66, net. Zone VIII was 1.39, net.
How much reduction (%) should I give my next batch of zone V and VIII negs to bring the zone VIII down to 1.30 net density? Should I worry about Zone V going down also, as it's already low? I use a diffusion enlarger. Omega D-2 w/ Zone VI head, Aristo V-54 lamp.
Bookmarks