I have the page setup the same as prior prints which printed properly. I had this happen a couple weeks ago and changed something which resulted in correct results. I'm using abs mode and 17x22 paper cut off a roll (flattened Canson Platine fiver rag) using rear manual feed and/or standard feed with the paper "pre-fed"* to the heads. What setting is causing this?
It's printing the image (8x20 file in this case) rotated 90 degrees counter-clockwise and in the middle of the paper. The sharpie marks show where it should be printing.
*i dunno what the terms are but I have had a 1121 error several times that makes an aweful sound and says to call service. I then shut off the printer, turn it on again and feed the paper out of the machine.
Reply With Quote
Bookmarks