I finally found an 8x10 enlarger (an old Durst Laborator 184) to print my 8x10 glass negs and am having a very confusing problem - any thoughts here would be greatly appreciated.
I am not getting full coverage of the negative and it doesn't look like fall off - it looks like an actual straight edge cropping my negs on all sides, even though the neg is perfectly centered in the carrier.
This enlarger should cover a 12x12 neg and my plates are 7 1/2" x 9 1/4". I have the condensers in the proper position according to the manual and am using a 240 lens.
Anybody know what is going on???
Thanks in advance for any assistance, I am really frustrated and dying to get to work.
Bookmarks