Search:

Well, finally I got rid of any banding problem installing the original Agfa software on a Windows XP box. Fotolook 3.6. I've even earned scan velocity, better highligts and some resolution and get...

I've made no further improvement. I've been told that most likely the problem comes from exhausted lamps. This thin cold cathode are supposedly easy to find as they are common to other appliances but...

I'm doing searchs in the forum looking for "Microtek banding" and there's a lot of new info (sadly a common problem). It seems that they rebranded the problems too.

Yes. I think this one is a rebranded Microtek.

Hello all,

I've got an Agfa Duoscan HiD for scanning 4x5 and 6x9 chromes and some negative. The main output is a web portfolio. 1500px on the long side and 90-100 dpi. So the resolution of the...

+1 . Same here

They seem F1's, and to be mounted incorrectly (or purposely) with the ground glass on the front bearer and knobs to the left. So either the owner was left handed, or for some reason the weaker F1...

Now I use the 410 with an older Arca Basic 4x5, and used the 3 way 029 Manfrotto head as well. The 410 is a joy to adjust and feels solid enough but when you make the test of appling some pressure...

My Arca

http://instagram.com/p/i83odXEaC5/

Yeahm if you mess with the instruction manual you always have the good ole loupe...

I have the same issue with a Sinar F2 I use. I don't use to rely for critical set up on camera levels or zero detents, that's why I carry a small level to check alignment of standards. But up to know...

Thanks for the advise. I've checked it and the measurement is exactly the same, so the shims are in the right place. Now I need a fresnel.

Thanks for the info Rod. Great to hear that. I knew about the standard 13mm recess lensboards of the later system.
Regarding this differences I have another question: I've got a flat lensboard with...

PM to brucep

Hey folks,

I've just got an Arca Swiss basic, axis tilt model, in like new condition. It came with the bag bellows and a flat board but it seems that because of the standards construction it...