I guess that was my point as well. My back ups are mostly for deciding later what development to give. Ultimately, I guess well, but sometimes I'd like to try to get a little more highlights or...
Type: Posts; User: mmmdoughnuts; Keyword(s):
I guess that was my point as well. My back ups are mostly for deciding later what development to give. Ultimately, I guess well, but sometimes I'd like to try to get a little more highlights or...
I am assuming that you mean develop them all. So, one use for the second copy is to also be able to change the developing if the first did not come out right. Obviously, if you develop the backups,...
Yes, there is a Zen feeling of completeness presented, but selfishly, I wish you would do more...
Still need to worry about stagnant flow on edges and corners. Let turbulence be your guide!
Cheers,
Andy
I think that I might have missed the train on contributing to this one...
For many reasons, I don't see an elegant solution using acoustics or vibration. These concepts are very predictable and...
This is my starting point, but I should have been Zone X instead of Zone V in my previous statement. You are correct that it is all visual, but I should only be off by less than 1/3 of a stop with my...
Not sure I see your point. What does it matter if I use the shutter speed, aperture, ND filter or step wedge in front of the negative to stop down my zone V reading to zone I. Using a step wedge and...
A few things to consider here. Surface waves on the top of the water (the ones that crash on the beach or ripple across a lake from a tossed stone), do not travel below the surface of the water. So...
My two light meters are equivalent to about 1/3 of a stop. I have built a LED source and used an oscilloscope to time my shutters at each speed so I believe that I am (within 1/3 stop) dealing with...
I am new to LF but not new to film, but I still have questions about developing. With 35 mm developing with an in camera spot meter, I have become good and repeatable with my small tank development,...
This is a great idea. I think I am going to make a 2x2 array to develop 4 at a time in my big print trays...
Not to hijack the thread further, but
Polypropolene peg board is nearly as inert and...
I am in for a go...
Now that I fully understand your request, I think it unlikely that you will be satisfied with this technique. The front standard is not permanently fixed to the focus rails. There are 5 or 6 screw...
Not to expensive at all for anAdhesive tape rule
Hope this helps!
Doughnuts!