need a source for Tundra case dividers
I recently picked up two Tundra equipment cases for a very good price - a medium and a large size.
Evidently, Tundra went out of business some time ago.
The problem is that I can't find a source of compatible dividers for these cases. If you haven't seen them, the dividers are a stiff corrugated board wrapped by grey padded fabric. The dividers slide into plastic "U" channels that have Velcro on the back which allows one to stick the channels to the case's fabric liner.
I contacted the OEM (Underwater Kinetics) which is based in England but they say they only made the case shells and have no idea where I might find any Tundra dividers.
Does anyone have any suggestions?
Please note: I do not want "pluck and pull" foam because I want the flexibility to easily change the layout which is the reason I bought the Tundra cases in the first place.
Thanks,
Terry
Re: need a source for Tundra case dividers
Terry: Check this thread in the "IY forum on making dividers from corrugated plastic board ("Cooplast") and H&L compatible fabric. Might be what you need.
http://www.largeformatphotography.in...t-for-Backpack
Re: need a source for Tundra case dividers
Quote:
Originally Posted by
Drew Bedo
Thank you! That is the DIY information that I needed.
Re: need a source for Tundra case dividers
My own project is in slow motion right now, but I am sure that we all would like to see what you do, and how it was done . . .and how you use the result.