Re: prevention of film holder light leaks
I don't think this is very complicated really. I only buy used holders and only use the ones that do not leak in direct sunlight. They are easy enough to test. I have about 40 good holders (4x5). Some I have been using for decades. The only ones I have had to retire were ones I did dumb shit with like dropping one from the roof of a 15 story building or dropping one in a stream (the film stuck so bad in the rails that I could never get the rails clean enough again).
Re: prevention of film holder light leaks
Quote:
Originally Posted by
Kirk Gittings
I don't think this is very complicated really. I only buy used holders and only use the ones that do not leak in direct sunlight. They are easy enough to test. I have about 40 good holders (4x5). Some I have been using for decades. The only ones I have had to retire were ones I did dumb shit with like dropping one from the roof of a 15 story building or dropping one in a stream (the film stuck so bad in the rails that I could never get the rails clean enough again).
Kirk:
I recently inherited two dozen 4x5 film holders when my father passed away in August. As a general rule, he took very good care of his equipment, so I assume they are in good working order. That being said, what is the proper way for me to test these holders for light leaks? Thanks in advance.
Jeff
Re: prevention of film holder light leaks
The standard test is to load them with paper (cheaper than film) and leave them in sunlight for awhile---flip them over halfway through the ordeal to subject both sides to the sunlight---then develop the sheets and see what leaks are exposed.
Re: prevention of film holder light leaks
SInce my film holders are always under the protection of the dark cloth, or in the dark room I don't worry about light leaks. If I get a light leak it is because I was careless wile photographing.