Does anyone still repair these?
Printable View
Does anyone still repair these?
What's wrong with it??? Usually the insulation in the wiring cords is shot, and connections may be open...
I posted a restoration post here a year or two ago, so search Graflarger for it...
Steve K
I plugged it in and it made all kinds of fizzy shorting noises so I unplugged it. Haven't found your post yet but still looking.
Ok, I think I found it.
http://www.largeformatphotography.in.../t-123165.html
So 1st thing is to replace the original (ancient) ac power cord and install a fuse.
I'll get to that tomorrow and I'll let you know how it works out. I am a bit nervous about the transformer but I hope that the only issue is the cord.
Nothing to do but try. :)
There are proper ways to repair vintage gear.
Applying power, then sniffing around for smoke and watching sparks do not quality.
- Leigh
That's the post...
Is the fizzy sound from the light head or box???
At this point, don't plug it in until some questions are answered...
Read the post carefully... (But sounds promising 'cause it somewhat works)... Ask questions...
Do you have a volt/ohm meter???
Good luck!!!
Steve K
If you've got any old retired tv repair or signal corps folks around, they could probably handle most of it. It should be pretty simple.
I opened up the light box and that part looks good. The cold light grid looks ok but until I can get power to it I won't be certain. (No scorched wires or black marks. :)) I didn't really expect that the power made it all the way through to this point since the switch was in the off position when I plugged it in but you never know.
Next I will pop the transformer box and see if I can start tracing continuity through the power wires. I do hope that the transformer didn't fry.
I do own a few electrical gadgets and tools including a volt/ohm meter. Nothing as nice as my son's Fluke but they will do for this device. If it does get to complicated I'll send it to him for a look.
I did a short stint as an apprentice to a TV repairman one or two years ago :cool: but I was too slow to make a living at it so I went on to other more lucrative pursuits.
I take it from everyone's responses that there are no qualified repair shops that handle this equipment any longer. :confused: