sheet film processing in film holders
Has anyone else heard of processing in the film holders?
An acquaintance of mine was telling me how he has processed sheet film in the film holders.
He has a rectangular light tight tank with a sealable top and has adapted dividers to hold the film holders vertical. In the dark he pulls the slides of 4 dual side holders, puts them in the tank and pours in the developer. Put on the top and the lights can go on. He follows the same process he used for roll film - tank inversion every 30 seconds - lights go off and pours out the developer and does the same for the stop bath and first fixer as he uses a two-step fixing procedure. He removes the film and used a tray process for the second fixer and then the wash.
I was concerned about contamination and staining with chemicals trapped behind the film in the holder and maybe that is one reason he uses a second tray for fixing. He claims he hasn’t had a problem, though he has only done B&W whereas I often do color and contamination could be a concern. He has always done it this way as he was shown by the person who sold him his setup years ago.
sheet film processing in film holders
Doesn't sound like a terribly good idea to me. What about the felt light trap in the holders? I can't imagine immersion would be too good for tape on the flap end either. Altogether it would be no go for wooden holders.
sheet film processing in film holders
sheet film processing in film holders
Hangers are a lot cheaper..EC
sheet film processing in film holders
I think someone is yankin' yer chain...
sheet film processing in film holders
If the guy isn't kidding I'd sure be careful about buying used sheet film holders.
sheet film processing in film holders
I process my film in the film holders while they're still in the camera. I go through a lot of cameras that way, but it's worth it in the long run.
sheet film processing in film holders
Why pull the dark slides at all? All you have to do is open them a little and then fill the holder with chemistry and then close the slide again and then each holder becomes it's own little daylight processing system. And while he's at it, he can just make an exposure and then fill the camera with the chemistry and process each sheet that way. That's where a good pan and tilt head comes in handy for proper agitation. The beauty thing is that by the time he gets home, all of his film is processed and ready for printing.
And when he gets home he just has to pull into the garage and tape the printing paper to the wall and tape the neg to the headlight to make the exposure. If the negs are dense he can use the high beams and the fog lights make great safe lights. And he can do two at a time if both headlights are working but this guy sounds like maybe one of his headlights has been out for a while now.
And so that light tight processing tank of his doesn't go to waste , he can put his digital camera in it to process his digital photos.
sheet film processing in film holders
They might be talking about a Polaroid back.
They almost look like holders and basically you process the film as your pulling it out of the holders.
sheet film processing in film holders
You might mean film hangers which is one way to develop sheet film.
I apologize for ther m,ockery that was made of your question. Too often that is how some of these forums operate.
There are other forums you might try
www.apug.org
www.viewcamera.com
steve simmons