Correct lubrication for metal sliding beds and tracks?
I have a 8x10 Kodak master view I have broken down and cleaned, it cleaned up really well. The tracks on the bed were gummed up with the old grease and a bit rough. I have them all nice and clean now and i'm wondering if I should apply a few drops of a med weight machine oil or something else? Also the KMV has brass cogs and track for focus. Those i was going to leave dry unless something is recommended?
Re: Correct lubrication for metal sliding beds and tracks?
Leave them dry. At most lube them with Rubbing Alcohol.
Re: Correct lubrication for metal sliding beds and tracks?
Quote:
Originally Posted by
Jim Noel
Leave them dry. At most lube them with Rubbing Alcohol.
Second that! (Rubbing alcohol is not just alcohol, it contains a little lubricant.) And Ryan, don't get any graphite powder lube anywhere near the camera. The stuff is like a nano contaminant and finds its way into lenses. Somehow.
Re: Correct lubrication for metal sliding beds and tracks?
Thanks, This goes for both the track bed and the focus rack and cog?
Quote:
Originally Posted by
ryanmills
I have a 8x10 Kodak master view I have broken down and cleaned, it cleaned up really well. The tracks on the bed were gummed up with the old grease and a bit rough. I have them all nice and clean now and i'm wondering if I should apply a few drops of a med weight machine oil or something else? Also the KMV has brass cogs and track for focus. Those i was going to leave dry unless something is recommended?
Re: Correct lubrication for metal sliding beds and tracks?
Quote:
Originally Posted by
ryanmills
Thanks, This goes for both the track bed and the focus rack and cog?
My opinion only - no grease if it has a brass driving gear or track. Grease just attracts dirt and dust. I just finished cleaning up such a setup, and now that the track and gear are clean (track polished, too), it's very smooth. Some of gears are actually bronze, not brass, and bronze is usually self lubricating.
Re: Correct lubrication for metal sliding beds and tracks?
For metal-to-metal sliding surfaces that might attract grit, Teflon dry-lubes are really effective. Hardware stores or bicycle shops are good sources.
Re: Correct lubrication for metal sliding beds and tracks?
I don't doubt the guys who say nothing at all, but I always put Renaissance Wax on such things. Provides lubrication, doesn't gunk up, provides protection. Slippery. Good for everything--metal, wood, whatever. And one tiny drop of oil on sleeve bearing type surfaces, like where rotating shafts are held. Just a very tiny drop.
Re: Correct lubrication for metal sliding beds and tracks?
I am a believer in lubricants. All parts lubricated will operate smoother and last much longer. For all of my LF cameras parts, I use CRC Heavy Duty Silicone lubricant. Its working temperature range is -40 to 400 degrees, and it appears to dry within one to two hours after its application so it does not attract dust and dirt. It can be used for nylon, rubber, metal, and nonmetallic surfaces.
Hope this helps.
Re: Correct lubrication for metal sliding beds and tracks?
Quote:
Originally Posted by
BrianShaw
For metal-to-metal sliding surfaces that might attract grit, Teflon dry-lubes are really effective. Hardware stores or bicycle shops are good sources.
I was going to suggest this as well, I have used a version from West Marine used to lubricate sail track. Highly effective without collecting dirt.
Re: Correct lubrication for metal sliding beds and tracks?
Be very careful with silicone and anything that might ever need refinishing.