View Full Version : T track on enlarger table. What for?
My 10x10 Fotar table was modified with t track and was used at a lab that did lots of retouching and dupe work. I need to rebuild the table and will likely leave it out but What would they have used it for? Holding down easels?
Assuming the tracks are on the top...
I expect it was used for clamping an easel in place so each print would be identical.
- Leigh
yeah, on top. I'm gonna make a new table since this one has absorbed too much moisture to be flat. Those tracks happen to be the same dimensions as the t-tracks in my router table so I'll save them for my miter saw bench.
dsphotog
27-Apr-2012, 09:28
To adjust and lock down a roll paper easel.
John Koehrer
29-Apr-2012, 19:31
Focomats used a track to lock down an easel. Maybe the T track is for accurate/repeatable positioning.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.