View Full Version : Seal Masterpiece 500 T - X
bob carnie
4-Apr-2011, 13:03
Hi Folks
My old faithful press is in need of a tune up, I am looking for a supplier of bushings for the handles that allow the platen to press down and lift up.
I am pretty sure Seal will not have these parts so wondering if anyone here has refurbished one of these workhorses and where they got the parts.
Seal Masterpiece 500 T-X 26 x34 inch model
any info is appreciated, blankets, new parts for the timer and heater.
thanks
Bob
Mark Sampson
4-Apr-2011, 15:51
Seal was bought out and their presses now have the 'Bienfang' brand name. IIRC their website is a bit complex but it's worth a few minutes to see if they can help.
bob carnie
5-Apr-2011, 05:53
Thanks Mark
Seal was bought out and their presses now have the 'Bienfang' brand name. IIRC their website is a bit complex but it's worth a few minutes to see if they can help.
Peter Mounier
5-Apr-2011, 07:19
When my Seal 210 press needed a new switch I found parts at FramersIsland.com
http://framersisland.com/mount-press-parts-c-39.html
Peter
Drew Wiley
5-Apr-2011, 08:23
In this part of the world, framing wholesalers carry parts for the older Seal presses.
bob carnie
5-Apr-2011, 09:18
Thanks all
I think I may have the bushings made locally and presently this looks like my best option.
Bob
Do you know the dimensions (accurately)?
Bushings are readily available from industrial suppliers, probably cheaper than from Seal and MUCH cheaper than having them custom made.
Where are you located?
- Leigh
Donald Miller
5-Apr-2011, 12:34
A bearing supply house typically has a variety of bushings.
bob carnie
5-Apr-2011, 13:15
Toronto
Do you know the dimensions (accurately)?
Bushings are readily available from industrial suppliers, probably cheaper than from Seal and MUCH cheaper than having them custom made.
Where are you located?
- Leigh
Robert Hall
5-Apr-2011, 14:57
The "official" parts manufacturer is here in Salt Lake City. You need to go through Beinfang to get part numbers and contact info. But at the prices they ask, it would probably be better to go to a local machine shop and have the hardware done for you.
I have also found a couple things out about the presses through my discussions with Bienfang, who, by the way, are pretty good to deal with.
If the red light is flickering for example on the power display telling you the head demand is on, it may mean the contact of the thermostat on the board is dirty. Usually removing the contact from the board and replacing it will improve the contact and the press will heat much quicker and maintain the heat better.
Regards,
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.