PDA

View Full Version : Enlarger lamp & graduation



Karl Beath
15-Nov-2001, 12:47
Hello from Karl

I have a 2nd hand Durst Laborator 1200 previous to this,I used a Durst colour he ad M670. With my previous enlarger I had exposure times, to use a specific exam ple, of 2min 40 at f16. Now I have exposure times of 12min at f16, for the same neg. The bulb is a 150W, it has a white covering. Could the bulb be old theref ore giving out less light than the previous bulb.

Secondly, on my column there is a graduation in inches and centimetres. There a re also graduations which I assume allow for exposure increase calculations with increasing height of the column. Invers square law. The problem is, I don't k now how to use them. Please could someone assist me.

Cheers and thanks Karl

matthieu l.s.
16-Nov-2001, 00:07
I don't think that the bulb is the problem; most probably, you are not using the good condenser/lens combination. In this type of enlarger you must use a particular set of condenser elements for each focal length (50, 80, 150) of the enlarging lens.

regards, Matthieu

Cesar Barreto
16-Nov-2001, 13:30
Karl,

Do you have any good reason to play at f/16? Durst enlargers alignes quite well so you may be confortable working with wider apertures. Short lenses usually work fine at f/5.6 or even less, while the bigger ones (135/150mm) are OK at f/8. You may also try Chyoda 250W bulbs, with the side benefit of being larger and providing better light eveness. Although I never use the column numbers it's understood that exposures will change in the same order as the square-to-distance table you find on flash exposure guides. I mean, as the picture's area doubles the exposure gets four times bigger. And so on ...

Good printing. Cesar B.