View Full Version : Is there a good one-shot fine -grain developer for FP4?
Yaakov Asher Sinclair
Is there a good one-shot fine-grain developer for FP4? I've been using Rodinal but find it a bit too grainy. As I don't do a lot of wo rk, a diluted developer sitting around will end up down the drain. Thanks in advance Yaakov Asher Sinclair
Ilfosol-S works very nicely with this film. It's my usual, but usually with HP5 .
Microphen is very nice also.
I print on a diffusion enlarger and usually find I have to develop about 15% longer than Ilford recomends. (Relatively soft lighting situations)
pat j. krentz
PMK is very good, and the concentrate will keep for over a year. Pat
I use JOBO's one shot chemestry for all i do 4x5, 2 1/4x3 1/4 120 roll film, att typs, prints, negs, cromes
This is a bit late, but try Ilfospeed diluted at 1-100 for approx 12 minutes or at 1-60 for 8 or so, you may prefer to add a couple of minutes to these times if you prefer.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.