Ansco 10x8 Picture needed

[brucep]

I've just about completed the rebuild of an Ansco 10x8 camera, but it is missing the part that holds the rail vertical when folded for transporting. Could anyone either photograph theirs, or point me to a picture (as I've failed to find one) so that I can make a new one as accurately as possible. That is unless the original fastener was rubbish, and someone can recommend an improved design as I am restoring it to use, not to put in a museum.

95784

Many thanks
Bruce

[Jac@stafford.net]

It is a simple, brass latch that pivots from the camera's body to the rail.
As shown here. (http://home.comcast.net/~webuycameras/1051o.jpg)

[Tony Lakin]

95912

[brucep]

Many thanks for the picture. It was the last bit I needed.

Bruce